電話:0317-8301766
傳真:0317-8187701
手機:13931777322
郵箱:hbakby@163.com
網址:www.54hnsh.com
聯系人:候經理
地址:泊頭市104國道西側南倉18號
Thank you for the trust and support of Ike pump industry for many years
電話:0317-8301766
傳真:0317-8187701
手機:13931777322
郵箱:hbakby@163.com
網址:www.54hnsh.com
聯系人:候經理
地址:泊頭市104國道西側南倉18號
1. Check whether the gear oil pump pipeline and joint are loose. Rotate the gear oil pump by hand to see if the gear oil pump is flexible.
2. Add bearing lubricating oil into the bearing body, observe that the oil level should be at the center line of the oil standard, and the lubricating oil should be replaced or supplemented in time.
3. Unscrew the water diversion plug of the gear oil pump body and fill the water diversion (or slurry diversion).
4. Close the gate valve, outlet pressure gauge and inlet vacuum gauge of the water outlet pipeline.
5. Jog the motor to see if the motor turns correctly.
6. Start the motor. When the gear oil pump operates normally, open the outlet pressure gauge and the inlet vacuum pump, and gradually open the gate valve according to the appropriate pressure, and check the motor load at the same time.
7. Try to control the flow and head of the gear oil pump within the range indicated on the label, so as to ensure that the gear oil pump operates at the highest efficiency point, so as to obtain the maximum energy-saving effect.
8. During the operation of gear oil pump, the bearing temperature shall not exceed the ambient temperature of 35C and the maximum temperature shall not exceed 80C.
9. In case of abnormal sound of gear oil pump, stop immediately to check the cause.
10. When the gear oil pump is to be stopped, first close the gate valve and pressure gauge, and then stop the motor.
11. Within the first month of operation, the gear oil pump shall change the lubricating oil after 100 hours, and then change the oil every 500 hours. 12. Adjust the packing gland frequently to ensure normal leakage in the packing chamber (drip leakage is preferred).
13. Regularly check the wear of shaft sleeve, and replace it in time after large wear.
14. When the gear oil pump is used in cold winter, after shutdown, unscrew the drain plug at the lower part of the pump body to drain the medium. Prevent frost cracking.
15. If the gear oil pump is out of service for a long time, it is necessary to disassemble the pump, wipe off the water, coat the rotating parts and joints with grease, install them and keep them properly